2. Connect the other end to the USB2.0 port on the host computer.
• This machine does not come with a USB interface cable. Make sure you purchase the appropriate
cable for the machine and your computer.
• The USB2.0 interface board is supported by Windows 2000/XP/Vista/7, Windows Server
2003/2003 R2/2008/2008 R2, Mac OS X 10.3.3 or higher.
• To use Macintosh, the machine must be equipped with the optional PostScript 3 unit. When used
with Mac OS X 10.3.3 or higher, a transfer speed of USB2.0 is supported.
• For details about installing the printer driver, see "Preparing the Machine", Printer Reference.
Connecting a Device to the Machine’s USB Host Interface
This section explains how to connect a device to the machine's USB host interface.
1. Connect one end of the USB interface cable to the machine's USB host interface.
2. Connect the other end of the USB interface cable to a card authentication device or media
slot.
• This machine does not come with a USB interface cable. Make sure you purchase the appropriate
cable.
Connecting to the Wireless LAN Interface
This section describes how to connect to the wireless LAN interface.
• Check the machine's IPv4 address and subnet mask, or the IPv6 address settings.
• For details about how to set the IPv4 address and subnet mask from the control panel of the machine,
see "Interface Settings".
2. Connecting the Machine
70
To Next Page
Loading...
