Message Problem and solutions
supplicant unbound The supplicant is not connected to the unbound
access point.
terminated. The IKE service has stopped because no
configurations for manual SA or IKE exist.
terminated. The bonjour (rendezvous) function is disabled.
There is problem in dhcp server operation. There is a problem with the DHCP server.
If multiple DHCP servers are active on the network,
check that they are assigning unique IP addresses
to each machine.
The print server received error <error number>
during attempt to log in to the network. Access to
the network was denied. Verify that the print server
name and password are correct.
Login to the file server failed when the print server
was online. The print server is not registered or a
password is specified. Register the print server
without specifying a password.
trap account is unavailable. v3Trap cannot be sent. This could be because the
Trap destination account is different from the
account specified by the machine.
unauthenticated The authentication failed. The supplicant was
denied access to the access point, or was not
authenticated.
Updated (option name)(value) via DHCPv6 Server The parameter obtained from the DHCP server has
been updated.
usbd is disabled. Plug and Play is unavailable because the machine
is in Security Mode. Enable USBD in Security
Mode.
waiting for keys The supplicant is waiting for the session key.
WINS name registration: No response to server
(WINS server address)
There was no response from the WINS server.
Check that the correct WINS server address is
entered. Also, check that the WINS server is
functioning properly.
WINS wrong scopeID=<scope ID> The scope ID is invalid. Use a valid scope ID.
4. Monitoring and Configuring the Machine
196
To Next Page
Loading...
