Locating the NCP folder manually
This section describes how to locate the NCP folder manually.
1. Press [Change] under "Path".
2. Enter the path where the folder is located.
3. Press [OK].
4. Press [Connection Test] to check the path is set correctly.
5. Press [Exit].
• If you set "Connection Type" to [NDS], and if the NDS tree name is "tree", the name of the context
including the volume is "context", the volume name is "volume" and the folder name is "folder", then
the path will be "\\tree\volume\context\folder".
• If you set "Connection Type" to [Bindery], and if the NetWare server name is "server", the volume
name is "volume" and the folder name is "folder", then the path will be "\\server\volume\folder".
• You can enter a path using up to 256 characters.
• If the connection test fails, check the settings, and then try again.
Locating the NCP folder using Browse Network
This section describes how to locate the NCP folder using Browse Network.
1. Press [Browse Network].
2. If you have set "Connection Type" to [NDS], a list of items in the NDS tree appears. If you
have set "Connection Type" to [Bindery], a list of items on the NetWare server appears.
3. Search for the destination folder in the NDS tree or NetWare server.
You can press [Up One Level] to switch between levels.
4. Select the folder you want to register.
5. Press [OK].
• Only the folders you are allowed to access appear in [Browse Network].
• If the languages used on the machine and the destination you want to view differ, the items in the list
may not appear correctly.
• Up to 100 items can be displayed in the list.
Registering Folders
235
To Next Page
Loading...
