Paper Thickness: Paper Tray
Specify the thickness of paper loaded in the paper trays.
If the copy image blurs or the translucent paper loosens, changing the paper thickness level may
improve results.
Default for Plain Paper: [3]
Default for Recycled Paper: [3]
Default for Translucent Paper: [2]
Default for Film: [3]
Refer to the chart below when selecting the mode for the paper thickness.
Thickness
Paper type
1 2 3 4 5
Plain Paper
110 g/m
2
(29.3 lb)
90 g/m
2
(23.9 lb)
70 g/m
2
(18.6 lb)
60 g/m
2
(15.9 lb)
51 g/m
2
(13.9 lb)
Recycled
Paper
110 g/m
2
(29.3 lb)
90 g/m
2
(23.9 lb)
70 g/m
2
(18.6 lb)
60 g/m
2
(15.9 lb)
51 g/m
2
(13.9 lb)
Translucent
Paper
70 - 90 g/m
2
(18.6 - 23.9
lb)
70 - 80 g/m
2
(18.6 - 21.3
lb)
70 - 80 g/m
2
(18.6 - 21.3
lb)
51 - 70 g/m
2
(13.9 - 18.6
lb)
Hemmed
paper
Film
0.07 - 0.095
mm
(2.8 - 3.7 Mil)
0.07 - 0.095
mm
(2.8 - 3.7 Mil)
0.07 - 0.095
mm
(2.8 - 3.7 Mil)
0.07 - 0.095
mm
(2.8 - 3.7 Mil)
-
When Plain Paper is used for printing in a low-temperature environment (temperature 10 °C, humidity
15%), change the thickness level from 3 to 2.
If the paper becomes loose when [Translucent Paper] is selected with a thickness level of 2, change
the thickness level to 1.
These settings do not apply for hemmed paper.
Depending on paper type, operating conditions (low temperature and humidity), and paper feeding
settings (multiple copies on paper of 542 mm, 22 in width or less), toner fusing conditions vary. To
improve toner fusing, change the thickness level to 3 2 1.
When using thin, soft, or limp paper, toner fusing may appear wrinkled or the image may be blurred.
If this happens, change the thickness level to 3 4 5.
When level 1 or 2 are selected for translucent paper, and you change the paper type from plain or
film to translucent, it may take longer for the machine to get ready for copying (up to two minutes).
Tray Paper Settings
27
To Next Page
Loading...
