The specified POP3/IMAP4 server name is used for [POP before SMTP].
Default: [Auto]
• Server Name
If DNS is in use, enter the host name.
If DNS is not in use, enter the POP3/IMAP4 or server IPv4 address.
Enter POP3/IMAP4 server name using up to 127 characters. Spaces cannot be entered.
• Encryption
Select Encryption as follows:
[Auto]
Password encryption is automatically set according to the POP/IMAP server settings.
[On]
Encrypt password.
[Off]
Do not encrypt password.
Administrator's E-mail Address
Specify the Administrator's E-mail Address.
On e-mailed scanned documents, if the sender is not specified this appears as the sender's address.
When sending e-mail, administrator's e-mail address will appear as the sender's address under the
following conditions:
When conducting SMTP authentication for the transmitted files under the e–mail function, the
Administrator's E-mail Address will appear in the "From:" box. If you have specified the user name
and e-mail address in [SMTP Authentication], make sure to specify this setting.
Enter up to 128 characters.
On e-mailed scanned documents, if [Auto Specify Sender Name] is [Off], specify the sender.
E-mail Communication Port
Specify the port numbers for receiving e-mails. The specified POP3 port number is used for [POP
before SMTP].
Default for "POP3": [110]
Default for "IMAP4": [143]
Enter a port number between 1 and 65535 using the number keys, and then press the [ ] key.
E-mail Reception Interval
Specify, in minutes, the time interval for receiving E-mail Notification function via POP3 or IMAP4
server.
Default: [On], [15 minute(s)]
File Transfer
41
To Next Page
Loading...
