• For details about how to specify wireless LAN settings from the control panel on the machine, see
"Interface Settings".
• p.31 "Interface Settings"
• p.273 "Configuring IEEE 802.1X"
Checking the Signal
This section describes how to check the machine's radio wave status.
When using in infrastructure mode, you can check the machine's radio wave status using the control panel.
1. Press the [User Tools/Counter] key.
2. Press [System Settings].
3. Press [Interface Settings].
4. Press [Wireless LAN].
5. Press [Wireless LAN Signal].
The machine's radio wave status appears.
6. After checking radio wave status, press [Exit].
7. Press the [User Tools/Counter] key.
2. Connecting the Machine
72
To Next Page
Loading...
