• To use this function, an optional punch unit must be installed to the optional Finisher attached to the
printer.
• Punch printing will be canceled under the following conditions:
• When a paper type that cannot be punched is selected.
• When a paper size that cannot be punched is selected.
• If positions other than those fixed for punching are specified.
• If there are inconsistencies between the orientation in duplex mode and the punch position.
• If there are inconsistencies between the orientation in letterhead mode and the punch position.
• When the punch receptacle has become full and Auto Continue is set (Printing will continue
without punching after the message appears).
• If there are inconsistencies between the staple position and the punch position, when using with
staple function.
• When the punching is cancelled, "Punch Cancelled." appears.
• Punching might not be in the specified position when printing on letterhead paper.
• If you cannot make punch settings even with the optional finisher installed, options may not be set
correctly in the printer driver. Correct option settings in the printer driver. For details, see the printer
driver Help.
• When duplex print is selected, adjust the punch position to the binding direction.
• Be sure to set the punch position the same as the staple position when using it with the staple function.
• Be sure to set paper size and orientation in the printer driver when punching.
• Depending on the application, print settings may not be enabled and printed output may not be as
expected.
• When setting Punch in the printer driver settings, make sure that a collate option is not selected in the
print settings of the application.
• If a collate option is selected in the application, printing will not be as intended.
• When using tracing paper, the vertical/horizontal position of the punches is opposite to the vertical/
horizontal position specified in the printer driver settings.
3. Other Print Operations
136
To Next Page
Loading...
Need help?
General