Using NetWare
This section describes the setting procedure for network printers in the NetWare environment. In the Net-
Ware environment, you can connect the printer as a "print server" or "remote printer".
• IPv6 cannot be used on this function.
Setting procedure
• When using the printer as a print server
1. Installing SmartDeviceMonitor for Admin
2. Setting the network interface board.
3. Turning the printer off and then back on.
• When using the printer as a remote printer
1. Installing SmartDeviceMonitor for Admin.
2. Setting the network interface board.
3. Setting NetWare.
4. Starting the print server.
• This procedure assumes an environment is already prepared for normal NetWare running
the printing service setting.
• The procedure is explained with the following example settings:
• File server's name …CAREE
• Print server’s name …PSERV
• Printer’s name …R-PRN
• Queue name …R-QUEUE
Using SmartDeviceMonitor for Admin
To use the printer in a NetWare environment, use SmartDeviceMonitor for Admin to set the NetWare
printing environment.
• The NetWare Client provided by Novell is required to set the printing environment using Smart-
DeviceMonitor for Admin under the following environments:
• NDS mode in Windows 95/98/Me
• NDS or Bindery mode in Windows 2000/XP, Windows NT 4.0
Using NetWare
293
To Next Page
Loading...
