Remote Maintenance by telnet
• Remote Maintenance should be password-protected so that access is allowed to administrators only.
• The password is the same as the one of Web Image Monitor administrator. When the password is
changed using "mshell", other passwords change also.
• Some commands cannot be used depending on your printer.
Using telnet
Follow the procedure below to use telnet.
• Only one user at a time can log on to perform remote maintenance.
1. Use the IP address or the host name of the printer to start telnet.
% telnet "IP_address"
2. Enter your user name and password.
Contact your administrator for information about the settings.
3. Enter a command.
4. Quit telnet.
msh> logout
The configuration message about saving the changes appears.
5. Enter "yes" to save the changes, and then press the [OK] key.
If you do not want to save the changes, enter "no", and then press the [OK] key. To make further
changes, enter "return" at the command line, and then press the [OK] key.
• If the message "Can not write NVRAM information" appears, the changes are not saved. Repeat the
procedure above.
• When the changes are saved, the network interface board is reset automatically with that changes.
• When the network interface board resets, the print job in print process will be printed. However, print
jobs in queue will be canceled.
6. Monitoring and Configuring the Printer
226
To Next Page
Loading...
Need help?
General