View settings
msh> hostname
IPv4 Configuration
msh> hostname "interface_name" "printer_name"
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name starting with "RNP" or "rnp"
• The Ethernet interface and IEEE 802.11b interface will have the same printer name.
• wlan can be specified only when the IEEE 802.11b interface unit is installed.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11b interface
Initializing the printer name for each interface
msh>hostname "interface_name" clear "name"
ifconfig
Use the "ifconfig" command to view and configure TCP/IP (IP address, subnet mask, broadcast address,
default gateway address) for the printer.
View settings
msh> ifconfig
IPv4 Configuration
msh> ifconfig "interface_name" "parameter" "address"
• If you did not enter an interface name, it is automatically set to the Ethernet interface.
• wlan can be specified only when the IEEE 802.11b interface unit is installed.
Interface name Interface configured
ether Ethernet Interface
wlan IEEE 802.11b Interface
The following explains how to configure an IPv4 address 192.168.15.16 on Ethernet interface.
msh> ifconfig ether 192.168.15.16
IPv6 Configuration
msh> ifconfig ether inet6 "interface_name" "prefixlen"
6. Monitoring and Configuring the Printer
236
To Next Page
Loading...
