7. Click [OK].
• Auto Run may not work under certain operating system settings. In this case, launch "Setup.exe"
located on the CD-ROM root directory.
• If you are required to restart the computer after installing SmartDeviceMonitor for Admin, restart the
computer and continue the configuration.
• SmartDeviceMonitor for Admin supports following languages: Czech, Danish, German, English,
Spanish, French, Italian, Hungarian, Dutch, Norwegian, Polish, Portuguese , Finnish, Swedish, Chi-
nese Simple and Chinese Traditional.
Changing the Network Interface Board Configuration
Follow the procedure below to change the network interface board configuration using SmartDevice-
Monitor for Admin.
1. Start SmartDeviceMonitor for Admin.
2. On the [Group] menu, point to [Search Device], and then click [TCP/IP], [IPX/SPX] or [TCP/
IP SNMPv3]. A list of printers using the selected protocol appears.Select the protocol of the
printer whose configuration you want to change.
If you are using TCP/IP SNMPv3, enter the user authentication.
3. In the list, select a printer whose configuration you want to change.
4. On the [Tools] menu, click [NIB Setup Tool].
A Web browser opens and the dialog box for entering the user name and password for the Web
Image Monitor administrator appears.
NIB Setup Tool starts when the network interface board is default. Follow the instruction on the screen.
5. Enter the login user name and password, and then click [Login].
For details about the login user name and password, consult your administrator.
6. Configure settings using Web Image Monitor.
7. Click [Logout].
8. Quit Web Image Monitor.
9. Quit SmartDeviceMonitor for Admin.
• For details about Web Image Monitor, see p.199 "Using Web Image Monitor".
6. Monitoring and Configuring the Printer
208
To Next Page
Loading...
Need help?
General