msh> web url http://"The URL or IP address you want to register"/
Deleting URLs registered as link destinations
msh> web x clear url
Specify "1" or "2" for x as the corresponding number to the URL.
Link name configuration
You can enter the name for URL that appears on Web Image Monitor.
Specify "1" or "2" for x as the corresponding number to the link name.
msh> web name "Name you want to display"
Resetting URL names registered as link destinations
msh> web x clear name
Specify "1" or "2" for x as the number corresponding to the link name.
Help URL Configuration
You can set URLs linked by clicking [Help] or [?] on Web Image Monitor.
msh> web help http://"Help URL or IP address"/help/
Deleting Help URL
msh> web clear help
wiconfig
Use the "wiconfig" command to make settings for IEEE 802.11b.
View settings
msh> wiconfig
View IEEE 802.11b settings
msh> wiconfig cardinfo
• If IEEE 802.11b is not working correctly, its information is not displayed.
Configuration
msh> wiconfig "parameter"
Parameter Value configured
mode {ap|adhoc|802.11adhoc} You can set the infrastructure mode (ap) , the
802.11 ad hoc mode (802.11adhoc), or the ad
hoc mode (adhoc).
The default is ad hoc mode.
Remote Maintenance by telnet
253
To Next Page
Loading...
Need help?
General