Address configuration
Use the following command to configure a WINS server IP address:
msh> wins "interface_name" {primary|secondary} "IP address"
• Use the "primary" command to configure a primary WINS server IPv4 address.
• Use the "secondary" command to configure a secondary WINS server IPv4 address.
• Do not use "255.255.255.255" as the IPv4 address.
NBT (NetBIOS over TCP/IP) Scope ID Selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "scope ID"
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11b interface unit is installed.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11b interface
6. Monitoring and Configuring the Printer
258
To Next Page
Loading...
