Messages Description
Error: Rem. Certificate Renewal An error has occurred in the remote certificate
renewal.
Error: USB Board An error has occurred in the USB board.
Error: USB Interface An error has occurred in the USB interface.
Error: Wireless Board An error has occurred in the wireless board.
Error: Wireless Card Wireless card is not inserted during start up, or
the IEEE 802.11b interface unit or the wireless
card is taken out after start up.
Exceed Booklet Stapling Limit The printing has exceeded the stapling limit of
the booklet finisher.
Full: Finisher Finisher tray is full.
Full: Finisher Booklet Tray Finisher booklet tray is full.
Full: Finisher Shift Tray Shift tray of Finisher is full.
Full: Finisher Shift Tray 1, 2 The shift tray 1 and 2 of Finisher are full.
Full: Finisher Upper Tray The upper tray of Finisher is full.
Full: Hole Punch Receptacle Punch Chip receptacle for hole punch is full.
Full: Log Data Capacity Log data capacity is full.
Full: Standard Tray Standard output tray is full.
Full: Waste Toner Waste toner is full.
Hex Dump Mode It is a hex dump mode.
Immed. Trans. not connected It did not connect directly with the other party of
the transmission.
Immediate Transmission Failed An error has occurred while transmitting directly.
Immed. Trans. not connected It did not connect directly with the other party of
the transmission.
Independent-supplier Toner Toner that is not recommended is set.
In Use: Finisher Other functions is using Finisher.
6. Monitoring and Configuring the Printer
262
To Next Page
Loading...
Need help?
General