Message Problem and solutions
Started. The bonjour function is enabled.
Terminated. The bonjour function is disabled.
The print server received error <error number> dur-
ing attempt to log in to the network. Access to the
network was denied. Verify that the print server
name and password are correct.
Login to the file server failed. The print server is not
registered or a password is specified. Register the
print server without specifying a password.
too many pictures. PictBridge printing failed because too many image
are sent during one print transacation. Reduce im-
ages at one print transaction.
trap account is unavailable. v3Trap cannot be sent. This could be because the
Trap destination account is different from the ac-
count specified by the printer.
usbd is disable. Plug and Play function and printing is disabled be-
cause usbd is disabled in the security mode.
Enable usbd in the security mode.
WINS name registration: No response to
server<WINS server address>
There was no response from the WINS server.
Check the correct WINS server address is entered.
Alternatively, check the WINS server is functioning
properly.
WINS wrong scopeID=<Scope ID> An invalid scope ID was used. Use a valid scope
ID.
wpa authentication Failed WPA authentication failed. Check the WPA con-
figuration.
wpa authentication started WPA authentication has started.
wpa IEEE802.1X started WPA authentication has started.
wpa connecting to authenticator WPA is connecting to authenticator.
wpa link up WPA key exchange has finished, and communica-
tion has been terminated.
wpa probe response doesn't have IE. WPA probe response does not have IE.
wpa success authenticated WPA authentication was successful.
6. Monitoring and Configuring the Printer
288
To Next Page
Loading...
Need help?
General