Ricoh C2000 User Manual

[Interval time = specified value with this switch x 2 sec]
Communication Switch 0A [SP No. 1-104-011]
No FUNCTION COMMENTS
0
Point of resumption of memory
transmission upon redialing
0: From the error page
1: From page 1
0: The transmission begins from the page where
transmission failed the previous time.
1: Transmission begins from the first page, using normal
memory transmission.
1-7 Not used Do not change the settings.
Communication Switch 0B – Not used (do not change the settings)
Communication Switch 0C – Not used (do not change the settings)
Communication Switch 0D [SP No. 1-104-014]
No FUNCTION COMMENTS
0-7
The available memory threshold,
below which ringing detection (and
therefore reception into memory) is
disabled
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each fax reception.
If the amount of remaining memory is below this threshold,
the machine cannot receive any fax messages.
If this setting is kept at 0, the machine will detect ringing
signals and go into receive mode even if there is no memory
available. This will result in communication failure.
Communication Switch 0E [SP No. 1-104-015]
No FUNCTION COMMENTS
0-7
Minimum interval between
automatic dialing attempts
06 to FF (Hex), unit = 2 s
(e.g., 06(H) = 12 s)
This value is the minimum time that the machine waits before
it dials the next destination.
Bit Switches
75
4

Ricoh C2000 Specifications

General

Category	Printer
Printing Technology	Laser
Print Speed (Black)	20 ppm
Print Speed (Color)	20 ppm
Duplex Printing	Yes
USB Connectivity	Yes