Ricoh D148 - Page 1109

Main SP Tables-3
D146/D147/D148/D149/D150 2-390 System Maintenance Section
Displays latest value of ID sensor sensitivity correction coefficient: K7.
3331
[ID.Sens Coef :Set]
Assign (no need with Tomahawk) for having compatibility with unification model
sires (Ap/At, Diana, Zeus).
001 K2: Upp Limit Corr *ENG [-0.20 to 0.40 / 0.17 / 0.01/step]
002 K2: Lwr Limit Corr *ENG [-0.40 to 0.20 / 0.03 / 0.01/step]
003 K2: Upp/Lwr Limit Coef1 *ENG [0.00 to 1.00 / 0.00 / 0. 01]
3331 [ID.Sens Coef :Set]
004
Kn: Upper *ENG [0.00 to 1.00 / 1.00 / 0.01/step]
Sets upper limit valid range of standardization value for specular reflection used
for calculating sensitivity correction: K5.
005
Kn: Lower *ENG [0.00 to 1.00 / 0.10 / 0.01/step]
Sets lower limit valid range of standardization value for specular reflection used
for calculating sensitivity correction: K5
006
K5: Upper *ENG [0.00 to 10.00 / 6.00 / 0.01/step]
Sets upper limit value of calculated sensitivity correction coefficient: K5.
007
K5: Lower *ENG [0.00 to 1.00 / 0.50 / 0.01/step]
Sets lower limit value of calculated sensitivity correction coefficient: K5.
008
K5: Target Point *ENG [0.00 to 1.00 / 0.15 / 0.01/step]
Sets proofreading point (Kn) of sensitivity correction coefficient: K5.
009
K5: Target Voltage *ENG [0.00 to 5.00 / 1.63 / 0.01V/step]
Sets proofreading point (Kn) of sensitivity correction coefficient: K5.
012
Corrct Coef:C *ENG [0.500 to 1.500 / 1.000 / 0.001/step]
Sets color diff correction coefficient (C) of Delta Vsp_Dif_Dash.
013
Corrct Coef:M *ENG [0.500 to 1.500 / 0.996 / 0.001/step]
Sets color diff correction coefficient (M) of Delta Vsp_Dif_Dash.