Fusing Unit
D146/D147/D148/D149/D150 4-106 SM
§ This screw is adjusted in the factory for the correct nip width, to match the hardness
characteristics of each roller. Do not adjust the pressure adjustment screw in the field.
§ Also, do not move the pressure roller to another fusing unit.
1. Heating sleeve belt unit (Heating sleeve belt unit)
2. Pressure roller [A] (
×2)
3. Apply the grease (FLUOTRIBO MG GREASE) to the rear shaft of the pressure roller at
5-7mm from the cut edge.
To Next Page
Loading...
