Service Call 441-498
SM 5-35 D146/D147/D148/D149/D150
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC443-00 C Image transfer encoder error/Image transfer unit set fault
During encoder count of the transfer motor, if there is no
effective edge interrupt for 1.5 sec, and there is an overflow for
1.5 seconds consecutively, it is determined that there is an
encoder error, SC443-00 is logged, and the system shifts to FG
control without stopping the transfer motor.
This error does not occur in this machine, because it does not
have an encoder.
§ Encoder defective
§ Transfer motor defective
§ Connector disconnected
§ Harness broken
§ Replace the image transfer unit
§ Replace the transfer motor
§ Reset the connector
§ Replace the harness
§ Ensure that SP2-920-07 to 009 is set to "1(FG)". It must not
be set to "0".
To Next Page
Loading...
