Ricoh FT 4015 - Page 102

Mode No. Function Settings
9
Output Check Use to turn on individual electrical components.
Enter the desired number given in the following
table.
Press the

key to turn on the electrical
component.
Press the

key to turn off the electrical
component.
10
Scanner Free
Run
Start a scanner free run.
Press the

key to start the free run.
Press the

key to stop the free run.
This mode is performed in accordance with the
selected paper size and magnification ratio.
11
All Indicators
On
Turns on all the indicators on the operation panel for
30 seconds. They will turn off automatically after 30
seconds.
To turn off the indicators, press the

key.
Component
No.
Electrical Component Note
1
Main Motor + Quenching
Lamp + Exhaust Fan
Motor (High Speed)
2 Charge Corona
3 Transfer Corona
4 Discharge Plate
5
Development Bias Voltage Standard Voltage
for Manual ID Level
4.
6 Erase Lamp All LEDs On
7
Machine Shut Off Main Switch Relay
Off.
8
Exhaust Fan Motor
(High Speed)
9 Optics Cooling Fan
10
Exposure Lamp + Optics
Cooling Fan
11 Toner Supply Motor
12
Toner Supply Motor
(Reverse)
14 Sorter Roller Drive Motor
15
Sorter Bin Drive Motor
(Bin Up)
Moves One Bin Up.
16
Sorter Bin Drive Motor
(Bin Down)
Moves One Bin
Down.
17 Registration Clutch
18 By-pass Paper Feed Clutch
19 Tray Paper Feed Clutch
21 Relay Roller Clutch
23 Total Counter
24 Key Counter Not Used
PROGRAM MODES 20 December 1996
4-12