Mode No. Function Settings
14
Auto Shut Off
Time Setting
(Energy Star)
Selects the auto shut off time.
0: 30 min.
1: 15 min.
2: 60 min.
3: 90 min.
4: 120 min.
The copier main switch is shut off automatically after
the selected auto shut off time, if SP77 is at "0".
15
Auto Reset
Time Setting
(Energy
Saver)
Selects an auto reset time of 1 or 3 minutes, or
cancels this mode.
0: 1 min.
1: 3 min.
2: None
The copier goes to energy saver mode
automatically after the selected auto reset time, if
SP78 is at "1".
16
Count
Up/Down
Selection
Selects count up or count down.
0: Up
1: Down
17
Narrow Paper
Select Mode
Selects narrow paper feed mode for the by-pass
feed table.
0: No
1: Yes
Use this mode to feed non-standard paper sizes
that are too narrow to be detected by the by-pass
feed paper end sensor. In this case, the copier will
operate even if the Add Paper indicator is on.
18
Auto Feed
Station Shift
(Japanese
Market Only)
Selects auto feed station shift mode.
0: Auto Shift
1: Manual
The copier automatically shifts to the paper feed
station holding the same size of paper when paper
runs out.
19
ADS Priority Specifies whether the copier defaults to ADS or
Manual mode when the main switch is turned on.
0: ADS
1: Manual
22
SADF Shut Off
Time
Selects the shut off time for SADF mode.
0: 5 s.
1: 60 s.
The DF must be installed on the machine.
24
Horizontal
Edge Margin
Width
Adjustment
Selects whether the side erase mechanism changes
when the optional document feeder is installed.
0: DF Mode
1: Always stays
in Platen Mode
See "Detailed Descriptions - Erase" for more details.
28
Auto Sort
Select
In Auto Sort Mode, the sorter is automatically
selected when more than 1 original is set on the DF
table and the entered copy quantity is greater than 1
and less than 11.
In Manual mode, sort mode has to be selected at
the operation panel.
0: Manual
1: Auto Sort
The sorter and DF must be installed on the machine.
29
Fusing
Temperature
Control
Selection
Selects the fusing temperature control mode.
0: ON/OFF
control
1: Phase
control
After selecting the control mode and turning the
main switch off/on, the fusing temperature control
mode is changed.
Service
Tables
20 December 1996 PROGRAM MODES
4-13
To Next Page
Loading...
