10. Reinstall the rear cover.
11. Plug the optics fiber cable [A] into the DF and the copier.
12. Plug the power supply cord [B] of the DF into the outlet in the copier rear
cover.
13. Attatch the voltage reference decal [C].
14. Check that the rubber pad [D] is in contact with the top of the operation
panel cover. If it is not, remove the DF grip [E] (2 screws), then adjust the
position of the magnet catch [F] so that the rubber pad is in contact with
the top of the operation panel cover.
15. Turn on the main switch and check the operation of the DF.
[B]
[A]
[C]
A662I505.wmf
[D]
[F]
A662I514.img
[E]
[F]
A662I515.img
Installation
20 December 1996 DOCUMENT FEEDER (A662)
3-11
To Next Page
Loading...
