5. Insert the DF [A] into the holes [B] in the copier upper cover.
6. Secure the DF to the copier (2 thumb screws [C]).
7. Remove the rear cover [D] (2 screws) and cut away the portion [E] with
cutting pliers as shown.
8. Locate the 4P connector [F] and connect it to the ADF interface board
[G], then secure the DF interface unit [H] to the copier (1 screw).
9. Plug the connector [I] (3P) in to CN202 on the ac drive dc power supply
board [J].
[A]
[C]
[B]
A662I502.img
[D]
[E]
A662I503.wmf
[F]
[G]
[J]
[I]
[H]
A662I504.wmf
DOCUMENT FEEDER (A662) 20 December 1996
3-10
To Next Page
Loading...
