Service Mode Table
G133 5-22 SM
Specifies the time for keeping the target temperature after recovery
(SP1105-083) without any jobs.
1115 [Stand-by Idling]
Interval *ENG
[1 to 240 / 60 / 1 min/step]
001
Specifies the interval between idling during stand-by mode.
This idling during the stand-by mode prevents the roller deformation.
Idling Time *ENG
[0 to 60 / 0.7 / 0.1 sec/step]
002
Specifies the length of each idling operation during stand-by mode.
1116 [Ends Temp. Correction] Not used
001 Mode: X1 *ENG
[0 to 999 / 40 / 1 sheet/step]
002 Mode: X2 *ENG
[0 to 999 / 70 / 1 sheet /step]
003 Mode: X3 *ENG
[0 to 999 / 100 / 1 sheet /step]
004 Detection Hysteresis *ENG
[1 to 20 / 5 / 1deg/step]
005 Saturation Temp. *ENG
[180 to 230 / 210 / defe/step]
006 Saturation Temp.: Margin *ENG
[30 to 130 / 130 / 1deg/step]
1159 [Fusing Jam Detection]
SC Display *ENG
[0 or 1 / 0 / 1 /step]
0: Disable, 1: Enable
001
Enables or disables the fusing consecutive jam detection.
If this SP is set to "1" (default: 0), SC559 occurs when the machine detects the
paper jam three times consecutively at the fusing unit.
To Next Page
Loading...
