Ricoh G133 - Page 350

Service Mode Table
G133 5-28 SM
014 Feed Clutch ON: Thick *ENG
[–10 to 10 / 0 / 1 mm/step]
1908 [Paper Bank Feed Timing Adj.] DFU
006 Feed Clutch ON: Plain *ENG
007 Feed Clutch ON: Thick *ENG
[–10 to 10 / 0 / 1 mm/step]
[Fusing Feed Start Time]
1910
Specifies the waiting time for feeding paper after the machine has entered the
print ready mode.
001 Plain: Normal Temp *ENG
002 Thick: Normal Temp. *ENG
[0 to 250 / 0 / 1 sec/step]
003
Middle Thick Constant
Speed: Normal Temp.
*ENG
[0 to 250 / 0 / 1 sec/step]
007 Plain: Low Temp. *ENG
008 Thick: Low Temp. *ENG
[0 to 250 / 0 / 1 sec/step]
009
Middle Thick Constant
Speed: Low Temp.
*ENG
[0 to 250 / 20 / 1 sec/step]
[Stand-by Recovery Rotation Speed]
1911
Selects the line speed for increasing the fusing temperature after recovery.
001 Low Temp. Setting *ENG
002 Normal temp. Setting *ENG
[0 or 1 / 0 / -]
0: 77 mm/sec
1: 205 mm/sec
1915 [After Ready Setting]
001
Correction Temp.: Plain:
Reload
*ENG
[0 to 50 / 10 / 1 deg/step]
⇒
⇒
Rev. 01/2007