Service Mode Table
SM 5-61 G133
Service
Tables
002 Execute: M -
003 Execute: C -
004 Execute: Y -
length detection.
[Main Scan Length Detection Disp.]
2185
Displays/adjusts the target value for the main scan magnification correction of
the line position adjustment.
After replacing the laser optics housing unit, input the standard value for Bk
provided with the new unit. For details, see "p.3-3 "Laser Optics Housing Unit""
in the "Replacement Adjustment" section. It is not necessary to input the
values for the other colors; these are automatically adjusted after doing the line
position adjustment.
001 Bk *ENG
[0 to 266667 / 249449 / 1 sub-dot/step]
002 M *ENG
003 C *ENG
004 Y *ENG
DFU
2186 [Main Scan Length Detection] DFU
Selection *ENG
[0 or 1 / 1 / 1/step]
0: OFF, 1: ON
001
Enables or disables the main scan length detection for the laser.
Paper Interval *ENG
[0 to 999 / 1 / 1 sec/step]
002
Adjusts the interval of the main scan length detection for the laser.
Freq. Selection *ENG
[0 or 1 / 0 / 1/step]
0: D-phase, 1: D-phase and PLL
003
Selects the correction method of the main scan length detection for the laser.
004 Freq. Threshold *ENG Not used
To Next Page
Loading...
