Ricoh G133 - Page 398

Service Mode Table
G133 5-76 SM
Plain: 205 mm/sec, Thick 1: 115 mm/sec, Thick 2&Fine: 77 mm/sec
001 Image Transfer: Plain *ENG
[10 to 250 / 90 / 5%/step]
002 Image Transfer: Thick 1 *ENG
[10 to 250 / 90 / 5%/step]
003
Image Transfer: Thick 2 &
FINE
*ENG
[10 to 250 / 90 / 5%/step]
004
Image Transfer: P/M
Pattern
*ENG
[10 to 250 / 100 / 5%/step]
P/M Pattern: When doing the process
control or automatic line position
adjustment.
[Common: HH]
2385
Adjusts the environment coefficient for each mode. When the environment is
detected as HH, SP2351 and SP2357 are multiplied by these SP values.
Plain: 205 mm/sec, Thick 1: 115 mm/sec, Thick 2&Fine: 77 mm/sec
001 Image Transfer: Plain *ENG
[10 to 250 / 80 / 5%/step]
002 Image Transfer: Thick 1 *ENG
[10 to 250 / 80 / 5%/step]
003
Image Transfer: Thick 2 &
FINE
*ENG
[10 to 250 / 80 / 5%/step]
004
Image Transfer: P/M
Pattern
*ENG
[10 to 250 / 100 / 5%/step]
P/M Pattern: When doing the process
control or automatic line position
adjustment.
[Plain: Bias]
2401
Adjusts the DC voltage of the discharge plate for plain paper.
Plain: 205 mm/sec, Fine: 77 mm/sec
001
Separation DC: Plain: 1st
Side
*ENG
[0 to 5000 / 1500 / 10 –V/step]