Service Mode Table
G133 5-124 SM
002 Separation DC: 1st Page *ENG
[Thick 6: Trailing Edge Correction] Thick 6 Paper: Trailing Edge Correction
2716
Adjusts the correction to the paper transfer roller current for the paper trailing
edge in each mode. SP2711 and SP2712 are multiplied by these SP values.
î The paper trailing edge area can be adjusted with SP2717.
001 Paper Transfer: 1st Side *ENG
[0 to 400 / 100 / 5%/step]
[Thick 6: T Edge: Timing]
2717
Adjusts the bias/voltage switch timing of the paper transfer roller/discharge
plate at the paper trailing edge between the erase margin area and the image
area.
001 Paper Transfer: 1st Side *ENG
[â100 to 0 / 0 / 1 mm/step]
[Thick 6: LL] Thick 6 Paper: LL Environment Coefficient Adjustment
2718
Adjusts the environment coefficient for each mode. When the environment is
detected as LL, SP2711 and SP2712 are multiplied by these SP values.
001 Paper Transfer: 1st Side *ENG
[10 to 250 / 80 / 5%/step]
002 Separation DC: 1st Side *ENG
[10 to 250 / 180 / 5%/step]
[Thick 6: ML] Thick 6 Paper: ML Environment Coefficient Adjustment
2719
Adjusts the environment coefficient for each mode When the environment is
detected as ML, SP2711 and SP2712 are multiplied by these SP values.
001 Paper Transfer: 1st Side *ENG
[10 to 250 / 90 / 5%/step]
002 Separation DC: 1st Side *ENG
[10 to 250 / 140 / 5%/step]
To Next Page
Loading...
