Ricoh G133 - Page 466

Service Mode Table
G133 5-144 SM
020
Paper Transfer: FINE: 2nd Side:
S5
*ENG
width)
[Special 3: Leading Edge Correction] Special 3 Paper: Leading Edge
Correction
2871
Adjusts the correction to the paper transfer roller current at the paper leading
edge in each mode. SP2852 and SP2857 are multiplied by these SP values.
Plain: 205 mm/sec, Thick 2&Fine: 77 mm/sec
 The paper leading edge area can be adjusted with SP2872.
001 Paper Transfer: Plain: 1st Side *ENG
[0 to 400 / 100 / 5%/step]
002 Paper Transfer: Plain: 2nd Side *ENG
[0 to 400 / 150 / 5%/step]
003 Paper Transfer: FINE: 1st Side *ENG
004 Paper Transfer: FINE: 2nd Side *ENG
[0 to 400 / 100 / 5%/step]
005-008
Adjusts the correction to the discharge plate current at the paper leading edge
in each mode. SP2851 is multiplied by these SP values.
 The paper leading edge area can be adjusted with SP2872.
005 Separation DC: Plain: 1st Page *ENG
006 Separation DC: Plain: 2nd Page *ENG
[0 to 400 / 100 / 5%/step]
007 Separation DC: Fine: 1st Page *ENG
008 Separation DC: Fine: 2nd Page *ENG
[0 to 400 / 100 / 5%/step]
[Special 3: L Edge: Timing]
2872
Adjusts the bias/ voltage switch timing of the paper transfer roller/ discharge
plate at the paper leading edge between the erase margin area and the image
area.
Plain: 205 mm/sec, Thick 2&Fine: 77 mm/sec