Service Mode Table
G133 5-224 SM
immediately after power on grants full address book access to all users.
Procedure
1. Turn the machine off.
2. Install the new HDD.
3. Turn the machine on.
4. The address book and its initial data are created on the HDD automatically.
5. However, at this point the address book can be accessed by only the
system administrator or key operator.
6. Enter the SP mode and do SP5846 041. After this SP executes
successfully, any user can access the address book.
046 IniSet/All AddrB Clears the information related with UCS.
047
Initialize Local Addr
Book
Clears the local address book information,
including the user code.
049
Initialize LDAP Addr
Book
Clears the LDAP address book information, except
the user code.
050 Initialize All Addr Book
Clears all directory information managed by UCS,
including all user codes.
051 Backup All Addr Book Uploads all directory information to the SD card.
052 Restore All Addr Book
Downloads all directory information from the SD
card.
053 Clear Backup Info
Deletes the address book data from the SD card in
the service slot.
Deletes only the files that were uploaded from this
machine.
This feature does not work if the card is
write-protected.
After you do this SP, go out of the SP
mode, and then turn the power off.
Do not remove the SD card until the
Power LED stops flashing.
To Next Page
Loading...
