Punch Unit (B807)
G133 1-32 SM
14. Connect the harnesses [P] to the main PCB.
15. Put the harnesses [Q] through the hole [R] in the rear frame (= x 1).
16. Install the punch drive motor [S] on the rear frame ( x 2).
17. Connect the drive motor harness [T] (yellow connector) to the harness from the punch
unit (= x 1).
18. Connect the home position sensor harness [U] (yellow connector) from the punch unit
to the home position sensor [V].
19. Install the sub-scan registration sensor unit [W] from the rear side ( x 2).
20. Route and connect the harnesses as shown (= x 2).
To Next Page
Loading...
