Punch Unit (B807)
SM 1-33 G133
Installation
21. Install the hopper full sensor arm [X] ( x 1, spring x 1).
22. Connect the harness from the sub-scan registration sensor unit to the hopper full
sensor [Y].
23. Install the hopper [Z] from the front side.
24. Reinstall the timing belt cover and knob.
25. Reinstall the rear cover (x 2).
26. Close the front door and top cover.
27. Install the 1000-sheet booklet finisher on the mainframe.
28. Plug in and turn on the main power switch.
29. Check the 1000-sheet booklet finisher operation.
To Next Page
Loading...
