Using the Printer Function
32
5
M Restart the printer.
Note
❒ To make sure the printer is correctly configured, enter the following from
the command prompt:
F:> USERLIST
❒ If the printer works as configured, the name of the print server appears as
an attached user.
NetWare 4.x, 5/5.1, 6
Important
❒ You must set up the print server using NDS mode in NetWare 4.x, 5/5.1, 6.
❖ To use NetWare 5/5.1, 6
• Use the printer as a print server. Do not use it as a remote printer in a
PureIP environment.
• If you use PureIP, configure the printer to use TCP/IP. For more informa-
tion about how to make the settings, see p.5 “"Network environment" de-
scribes a situation where the printer is connected to a computer via
wireless LAN.”.
A Log on to the file server as an administrator, or equivalent.
B Start SmartDeviceMonitor for Admin.
C On the [Group] menu, point to [Search Device], and then click [IPX/SPX] or
[TCP/IP].
A list of machines appears.
D In the list, select the printer for which you want to change configuration.
E On the [Tools] menu, click [NIB Setup Tool].
NIB Setup Tool starts.
Reference
If you use NetWare 5/5.1 or NetWare 6 in a PureIP environment, see p.34
“Using PureIP in the NetWare 5/5.1, 6 environment”.
F Click [Wizard], and then click [OK].
G If necessary, enter the print server name in the [Device Name:] box, and then
click [Next >].
H Select the [NetWare] check box, and then click [Next >].
To Next Page
Loading...
