Printing with NetWare
39
5
G Click the [NetWare] tab, and then make the following settings:
A In the [Logon Mode] area, select [File Server Mode] or [NDS mode].
Note
❒ If [File Server Mode] is selected, a connecting destination will be chosen
based on the string entered in step C.
❒ If [NDS mode] is selected, a connecting destination will be chosen based
on the string entered in step D.
B In the [Print Server Name:] box, enter the name of the print server.
Important
❒ Use the same name as that of the print server name to be set from
NWadmin (
M
-C).
Limitation
❒ Enter up to 47 alphanumeric characters.
C In the [File Server Name:] box, enter the name of the file server in which a
print server is to be created.
By clicking [Browse...], you can select a file server among those listed in the
[Browse...] dialog box.
Limitation
❒ Enter up to 47 alphanumeric characters.
D In the [NDS Tree:] box, enter the NDS tree name in which to make the file
server.
By clicking [Browse...], you can select the NDS tree name and NDS context
name from their lists.
Limitation
❒ Enter up to 32 alphanumeric characters (“-” and “_” can be used).
E In the [NDS Context:] box, enter the context in which the print server is to
be created.
Limitation
❒ Enter up to 127 alphanumeric characters.
F In the [Print Server Operation Mode] area, click [As Remote Printer].
G In the [Remote Printer No.] box, enter the number of the printer.
Important
❒ Use the same number as that of the printer to be created in the print
server (
N
-D.)
H Click [OK] to close the [NIB Setup Tool - Network board list] dialog box.
H Quit SmartDeviceMonitor for Admin.
To Next Page
Loading...
