Appendix
76
9
Print Speed
Specify the print speed.
command=value of print speed
The following example shows the command for specifying “printspeed_3”
printing: (host name: nphost, file name: file1):
•rcp
% rcp file1 nphost:command=printspeed_3
•ftp
ftp> put file1 command=printspeed_3
Skip Feed
Specify the number of drum idle rotations.
command=value of skip feed
Print speed Value
The print speed can be set to between 1 (slow-
est) and 6 (fastest).
printspeed_1
printspeed_2
printspeed_3
printspeed_4
printspeed_5
printspeed_6
Settings are not specified. printspeed_none
Skip feed Value
If you select “1”, printing is performed nor-
mally.
skipfeed_1
skipfeed_2
skipfeed_3
skipfeed_4
skipfeed_5
skipfeed_6
skipfeed_7
skipfeed_8
skipfeed_9
Settings are not specified. skipfeed_none
To Next Page
Loading...
