Appendix
90
9
SMB
Use the “smb” command to configure or delete the NetBEUI settings such as the
computer name or workgroup name.
msh> smb parameter
Note
❒ You cannot use a computer name starting with “RNP” or “rnp”.
ROUTE
Use the “route” command to control the routing table.
This command allows you to configure and display routing information. You
can change the network configuration from remote computers using this com-
mand.
Note
❒ The maximum number of routing tables is 16.
*1
IP address
Parameter Settings
comp Your computer name consisting of up to 15 characters
group Workgroup name consisting of up to 15 characters
comment Comment consisting of up to 31 characters
notif {on | off} You can enable or disable notification of print job completion.
clear comp Clears the computer name
clear group Clears the Workgroup name
clear comment Clears comment
Commands Topics of setting
route add {host | net}
destination
*1
gateway
*1
Adds a host/network route to “destination”, and a gateway ad-
dress to “gateway” in the table. Host becomes the default.
route delete {host | net}
destination
*1
Deletes a host/network route from the table. Host becomes the
default.
route get {destination
*1
}
Displays only route information corresponding to a specified
destination. When the destination is unspecified, all routing in-
formation is displayed.
route active {host | net}
destination
*1
on | off
You can turn the specified destination on or off. Host becomes
the default.
route add default gateway
*1
You can set the default gateway address.
route flush Deletes all routing information.
To Next Page
Loading...
