Problem Cause Solution
To make further adjustment, carry out
the following procedure:
1. Press the [Standard Procedure]
key.
2. Press [Media Feed Adjustment].
3. Press [Micro Setting].
4. To reduce uneven density, enter a
negative value. To reduce black
streaks, enter a positive value.
Adjust the value in steps of
approximately ±4.
5. Press [Close] to close the setting,
and then execute printing.
• If [Level Setting] is set to [Off],
adjust the value in steps of
approximately ±4 within the
range of ±50.
• To reduce uneven density when
printing with white ink, enter a +
value. However, take care to
enter an appropriate value
because the density becomes
noticeably uneven if the value is
too high.
• It is recommended you adjust the
value one by one according to
the printed media, print mode,
and operating environment.
When You Cannot Print as Expected
181
To Next Page
Loading...
