9. Troubleshooting Guide RICOH Ri 2000 User Manual
230
After adding approximately 1 ml, pour the remaining cleaning solution in the dropper one drop
at a time into the cap until the liquid level is raised slightly above the rim of the cap, as shown in
the illustration below, when viewed from the side.
This should be done for all caps.
If bubbles are generated, please use a dropper to suck out the bubbles, as they may not
protect the head properly.
Move the cleaning solution in the head protection cover under the carriage so as
not to spill it.
When the head protection cover is tilted, the angle at which the cleaning liquid inside the cap
spills out is "left to right: approx. 30 degrees" and "front to back: approx. 10 degrees" when the
head protection cover is filled with cleaning liquid to the target state.
To Next Page
Loading...
