Ricoh Scanner - Changing a Registered Program

Various Scan Settings
134
6
Changing a Registered Program
To change the settings registered to a program:
A Press the {Program} key.
B Press [B Recall].
C Press the number of the program you want to change.
D Change settings of the program.
E Press the {Program} key.
F Press the number of the program whose settings you changed or the number
of a different program in which you want to register the changed settings.
G If you select a program that is already registered, a confirmation message
appears. To overwrite the program, press [Yes].
If you select a new program number, you can omit this step. Proceed to the
next step.
H Enter a program name.
I Press [OK].
If overwritten, the registered program is deleted.
The new program name appears briefly, and then the initial screen reappears
after a moment.