Figure 3-4 Network setting interface
In this interface, you can set desired IP parameters, and then click “Apply” to apply
the new setting or click “Cancel” to cancel the setting. To restore the factory defaults,
click “LAN Configuration Initialize”.
Note:
If a password is necessary for the entrance of the web, click “Network Settings” and
to enter the following dialog, here you should enter the correct user name and
password (the default user name and password are empty). To create a new
password or modify the password that has already existed please refer to “(4)”.
(3) Click “Help” and enter the help interface for the information about the
instrument and network, see figure below:
To Next Page
Loading...
