To Next Page

To Previous Page

Contact your network administrator for a valid subnet mask and set it manually.

The format of the subnet mask address is nnn.nnn.nnn.nnn; wherein, the range

of the nnn is from 0 to 255.

Enter the desired subnet mask using the front-panel parameter input area or the

virtual keypad. This setting is non-volatile. The instrument will load your subnet

mask automatically at the next power-on if “DHCP” and “Auto IP” are set to

"OFF".

• DNS

Contact your network administrator for a valid DNS address and set the address

manually. The format of the DNS address is nnn.nnn.nnn.nnn; wherein, the first

nnn ranges from 1 to 223 (excluding 127), and the other three range from 0 to

255.

Enter the desired DNS address using the front-panel parameter input area or the

virtual keypad. This setting is non-volatile. The instrument will load your DNS

address automatically at the next power-on if “DHCP” and “Auto IP” are set

to "OFF".

• Default Settings

Tap Default and a prompt message “Restore to default network settings” is

displayed. This operation enables DHCP and Auto IP and disables Manual IP.

• Apply

Tap

Apply to apply the current settings and revert to the Interface Settings

menu.

TIP

Note that you must tap

Apply to save and apply the network settings.

13.3.3 USB Configuration

In the Interface Settings menu, tap USB Config to enter the interface as shown in the

figure below. The interface displays the USB information.

You can tap

USB Config again to collapse the current menu to revert to the Interface

Settings menu.

Utility

DP900 User Guide

Rigol DP932A User Manual

Questions and Answers: