1. Edit a command file that meets the above requirements and store it to a USB
storage device.
2. Start the instrument and insert the USB storage device. Press the front-panel
or tap >Store to open the store and recall interface.
3. In that interface, read the command file according to
Store and Recall
.
• Send command via Ultra Sigma to lock or unlock the specified key
- Set up communication between the instrument and PC.
- Run Ultra Sigma and search for the instrument resources.
- Open the remote command control panel to send commands.
• Program and send command to lock or unlock the specified key.
- Set up communication between the instrument and PC.
- Use a programming language (e.g. LabVIEW, C#) to program and send
command.
Locking/Unlocking the Front Panel
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
DP900 User Guide
79