Rigol DS4024 User Manual

Chapter 6 Operations and Measurements RIGOL
MSO4000/DS4000 User’s Guide 6-27
operation formula is:
°360×=
sourceA
FF
FF
Period
BDelayA
BPhaseA
Wherein,
FF
BPhaseA
denotes phase A →B ;
FF
BDelayA
denotes delay
A
→B ;
sourceA
Period
denotes the period of source A.
7. Phs A
→B : the phase difference (expressed in degree) between the
threshold middle value of the rising edge of source A and the threshold middle
value of the falling edge of source B. The operation formula is:
°
360×
=
sourceA
F
R
F
R
Period
B
DelayA
B
PhaseA
Wherein,
F
R
B
PhaseA
denotes phase A →B ;
F
R
B
DelayA
denotes delay
A
→B ;
sourceA
Period
the period of source A.
8. Phs A
→B : the phase difference (expressed in degree) between the
threshold middle value of the falling edge of source A and the threshold middle
value of the rising edge of source B. The operation formula is:
°360×=
sourceA
R
F
R
F
Period
B
DelayA
B
PhaseA
Wherein,
R
F
BPhaseA
denotes phase A →B ;
R
F
B
DelayA
denotes delay
A
→B ;
sourceA
Period
the period of source A.
Note:
 Source A and source B can be any of CH1 to CH4 or D0 to D15. You can set them
via Measure  Setting  Type  “Delay” (“Phase”). For the setting method,
refer to “Specify the measurement source”.
 The default value of the threshold middle value is 50%. You can also set it via
Measure  Setting  Type  “Threshold”. For the setting method, refer to
“To Set the Threshold”.
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30

Rigol DS4024 Specifications

General

Brand	Rigol
Model	DS4024
Category	Test Equipment
Language	English