Chapter 14 System Function Setting RIGOL
MSO4000/DS4000 User’s Guide 14-7
“Power-on Load” (Utility System Power On) is set to “Last” and
“DHCP” and “Auto IP” are “Off” at the next power-on, the oscilloscope will load
the preset IP address automatically.
5. Set the subnet mask (when Static IP configuration type is used)
The format of the subnet mask is nnn.nnn.nnn.nnn; wherein, the ranges of the
nnn are all from 0 to 255. You are recommended to ask your network
administrator for a subnet mask available.
Press Mask and turn the multi-function knob to input the desired subnet
mask (for the setting method refer to “Network Parameter Setting
Method
”). This setting will be saved in the non-volatile memory and if
“Power-on Load” (Utility System Power On) is set to “Last” and
“DHCP” and “Auto IP” are “Off” at the next power-on, the oscilloscope will load
the preset subnet mask automatically.
6. Apply the network parameter configuration
After configuring the network parameters, press Apply to validate the current
network parameter settings.
Note: The network parameters newly configured will only take into effect when
Apply is pressed. At this point, the current network setting information in the
network connection setting interface will be updated according to the current
network parameter configuration.
7. Initialize the network parameters
Press Initialize to restore the network parameters to the default state.
Note: You can only initialize the network parameters when the oscilloscope is
correctly connected to the network.
8. mDNS
Press mDNS to enable or disable the multicast Domain Name System (mDNS).
This system is used to provide the function of DNS server for service discovery in
a small network without a DNS server.
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30
To Next Page
Loading...
