Rion VM-55 - Setup Files; Resume Function; Loading a Start up Fi Le at Startup

112
Setup Files
Resume function
When power to the unit is turned on, the measurement screen appears. The
settings active at this point are the same as were selected before the unit was
last turned off (resume function).
Note
When the unit is started while a start up  le exists
on the inserted SD memory card, the start up  le
load function (see the following description) will be
executed  rst.
Loading a start up  le at startup
If a start up  le exists on the inserted SD memory card, a selection screen
such as shown at bottom will appear.
Selecting [Yes] at the screen will load the start up  le.
Selecting [No] at the screen will cause the resume function to re-establish
the same settings as before the last time the unit was turned off.
Refer to page 116 about setting of start up  le.