Rion VM-55 - Max Hold Reset (S); Output Setting (S;R); Output Type (S;R)

154
Serial Interface
Max Hold Reset
Max hold reset
Reset the max hold value
Setting command Max
Hold Reset, p1
Parameter p1= “Off”
p1= “On”
The value is reset regardless of a parameter.
This command is invalid except for when the max hold screen is displayed.
I/O
OUTPUT
Output setting
Setting signal output
Setting command OUTPUT, p1
Parameter p1= “Off”
p1= “On”
Request command OUTPUT?
Response data d1
Returned value Same as for setting command
OUTPUT Mode
Output type
Setting output signal type
Setting command OUTPUT Mode, p1
Parameter p1= “AC”
p1= “DC”
Request command OUTPUT
Mode?
Response data d1
Returned value Same as for setting command