25-30 Carpet
A. Forward (Floor) Carpet Assembly Removal
1. Refer to Figure 25-2. Remove adjustable and/or removable pedals, as required.
2. Remove hardware securing scuff plates (and carpet) to cabin floor. Detach carpet
from floor via hook and loop tape (Velcro).
B. Forward (Floor) Carpet Assembly Installation
1. Refer to Figure 25-2. Attach carpet to floor via hook and loop tape (Velcro).
2. Install scuff plates; install B392-3 left-side cover (may be installed when pedals are
removed), as required.
3. Install adjustable and/or removable pedals, as required.
C. Aft (Floor) Carpet Assembly Removal and Installation
1. Refer to Figure 25-2. Attach or detach carpet to and from floor via hook and loop
tape (Velcro).
D. Carpet and Liner
CAUTION
Use caution when removing adhered carpet if carpet is intended
for reuse.
1. Removal
a. Starting at corners, gently peel back carpet by hand, or with plastic wedge or
putty knife.
b. Dampen old adhesive with Dupont Prep-Sol (or equivalent) to facilitate removal.
2. Installation
a. Verify proper carpet fit. Trim as required (do not trim carpet welt).
b. Apply B270-8 adhesive to bonding surface and carpet backing. Press carpet
to surface, smooth wrinkles, and remove excess adhesive prior to curing.
APR 2019 Chapter 25 Furnishings Page 25.11
To Next Page
