5-36 Torque Stripes
If, during inspection, the remaining torque stripe on a fastener is insufficient to determine
joint integrity, then remove accompanying palnut as required and apply specified torque
to fastener. If fastener moves, disassemble joint and inspect parts for damage such as
fretting, thread deformation, hole elongation, etc.; replace damaged parts. If fastener
does not move, install new palnut as required & standard torque per § 20-32. Torque
stripe fastener per § 20-31.
JUL 2020 Chapter 5 Inspections Page 5.7
To Next Page
Loading...
