92-184 PA16-series Pod Antenna (continued)
E. Configurations for Flight
1. Configuration for Flight with Pod Antenna Removed
a. Remove PA16-series pod antenna per Part A.
b. Remove hardware securing D586 brackets to F794-2 panel and remove
brackets.
c. Install clean, dry plastic bags individually over exposed cable assembly
connectors to prevent moisture or debris from contacting connector sockets/
pins; secure with ty-raps. Install clean, dry plastic bag over bagged cables/
connectors; secure with ty-raps. Verify security.
d. Revise Weight and Balance Record in R66 Pilot’s Operating Handbook (POH)
Section 6 to incorporate the following data:
Subtract:
Weight Long. Arm Long. Moment Lat. Arm Lat. Moment
18.1 lb 80.7 in. 1460.7 in.-lb 0 in. 0 in.-lb
2. Configuration for Flight with Pod Antenna Installed
a. Remove and discard ty-raps and plastic bags securing cable assemblies
together and ty-raps and bags protecting connectors.
b. Install hardware securing D586 brackets to F794-2 panel. Verify security.
c. Install PA16-series pod antenna per Part B.
d. Revise Weight and Balance Record in R66 Pilot’s Operating Handbook (POH)
Section 6 to incorporate the following data:
Add:
Weight Long. Arm Long. Moment Lat. Arm Lat. Moment
18.1 lb 80.7 in. 1460.7 in.-lb 0 in. 0 in.-lb
Page 92.31A Chapter 92 ENG Version JUL 2020
To Next Page
