Page 5.36 Chapter 5 Inspections JUL 2020
5-45 100-Hour / Annual Inspection
CABIN
General Interior:
Inspect condition. Verify general cleanliness of cabin and seat compartment interior.
Verify no loose objects or equipment, which could foul controls or injure occupants
in a hard landing. Verify legibility of placards and markings. Verify serviceable
condition of switches, knobs, handles, and other controls.
Seat Belts & Shoulder Harnesses:
Inspect condition. Verify no fraying or broken stitching of seat belts or shoulder
harnesses. Verify no significant UV damage. Check inertia reels for proper operation
by pulling harness quickly to verify locking function. Check buckles for proper
operation. Check belt and reel attachment points for security. Verify no cracks in
seat belt anchor welds. Verify security.
NOTE
TSO tag not required on factory-installed harnesses.
Windshields & Windows:
Inspect condition. Verify no significant UV damage (yellowing). Minor defects
or imperfections that do not impair pilot visibility or indicate impending structural
failure are acceptable. Refer to § 52-30 for damage and repair limits. Verify proper
installation and security.
Static Ports:
Inspect condition. Verify no obstructions.
To Next Page
